Your cart is currently empty |
Subtotal: | $0.00 |
This Outback Solutions Drawer module measures 37.20"L x 19.88"W x 11.02"H. Outback Solutions modules can be installed into any application providing sufficient space and anchorage is present. Unlike other roller drawer systems you are not limited to traditional roller drawer applications. Canopied / covered flat-beds, pickups, covered trailers, SUVs, vans, trucks, buses and sheds are just a few of the applications you might consider. Side floor kits are available for popular vehicles; however they are not mandatory fitment in any application.
Feartures:
Dimensions: |
Modules w/ Same Width: |
Modules w/ Same Height: | Modules that can stack on top | Modules that can stack on |
37.20"L x 19.88"W x 11.02"H |
RD1355US |
RD945US RD745US RD1045US RD845US RDRF945US RDRF1045US |
RD945US RDRF945US RF945US RD745US |
RD1355US RD945US |
NOTE: 53.35" long modules are 12.20" high. All other modules are 11.02" like this one. |
Building a Custom Roller Drawer System requires care, but allows you to create a unique solution for your vehicle. When selecting modules, carefully consider the length, width, height and the compatibility of the modules you intend on putting together. Fitting time will be dependent on the complexity of installation. Allow 1.5 hours per module with good access to the under floor, allow additional time if vehicle components require removal and refit. Be particularly aware of fuel tank location.
The Process:
1. Measure the area available for installation, width, length and height
2. Evaluate the vehicles floor for suitability of mounting, including potential bolt locations and accessibility to the underside floor
3. Using the module complement charts or the module data sheet, choose the desired combination of modules
4. Choose lower modules first
5. Choose stack modules second
6. Consider accessories, floor kits and stack extension panels
7. Review your selection
Double & Multi Modules:
Stacked Modules:
![]() |
![]() |
1. Grab Handle Slam Latches - These beautifully engineered lockable Reinforced Nylon Latches are a joy to use and are purpose designed by us to last a lifetime. Pull to open - Push to close. |
2. Purpose Folded Stainless Steel - When the drawer is rolled out slightly, there is absolutely no side to side movement! |
![]() |
![]() |
3. Attractive aluminum edging covers bearings, Hard wearing plastic trim, Commercial U.V. stable carpet made in New Zealand, Drawer and trays lined with automotive carpet.. | 4. Anti-rattle side guides stop up against rear bearings. |
![]() |
![]() |
5. Anti-rattle side guides stop up against rear bearings. | 6. Anti-rattle side guides ensure drawers track true and lock down under top bearings preventing any movement, rattles or wear. |
![]() |
![]() |
7. No side to side or up/down movement with the drawer shaken hard. NOTE: The large internal drawer dimensions |
8. Anti-rattle side guides and fridge roller rails lock under top bearings prohibiting any up/ down or side to side movement. |
![]() |
![]() |
9. Unique safety hand gap avoids unnecessary injury. Imagine this with a heavy load and no safety hand gap! | 10. Retaining pin to place in hole on side of drawer runner. |
![]() |
![]() |
11. To retain the Fridge Roller in open position use retaining pin to place in hole on side of Fridge Roller. | 12. Four (4) Fold Down Anchor Points supplied with Fridge Roller option. |